Choosing the Right Remote Solution for Your CNC
Explore our guide to Fagor-compatible remotes. From 5-axis CNCPD Teach Pendants to 3-axis One-Button remotes, find the perfect drop-in replacement.
Finding the right remote interface is critical for efficiency, especially when navigating complex 5-axis trims or standard 3-axis setups. Here is a breakdown of the best solutions for your Fagor-controlled machines.
Top Solutions for 5-Axis Machines
If you are running a 5-axis setup, you need a full Teach Pendant. While modern CAM has reduced the need to “teach” every point, these remotes remain the fastest way to write manual trim programs.
- CNCPD Remote Teach Pendant (SKU: CNCPD Remote)
- Best For: Fagor 8050, 8055, and 8065.
- Compatibility: A 5V drop-in replacement for discontinued Motionmaster pendants.
- The Advantage: Our preferred remote for 5-axis retrofits. It features a 25’ cord and is fully repairable (or available for repair-exchange).
- Euchner HBA-119903 (SKU: 03200015)
- Compatibility: Replaces the discontinued SKU 03200006.
- Note: This is the 5V comparable unit to our CNCPD remote, but uses a different plug and is not customer-interchangeable. Features a 15’ cord.
Top Solutions for 3-Axis Machines
For 3-axis machines, a simpler one-button remote is often more ergonomic and cost-effective.
- CNCPD One-Button Remote
- Best For: Fagor 8035 through 8060 models.
- Versatility: Unlike the standard Fagor 100p, we offer custom connections: D-sub (direct to controller), round port (machine body), or flying leads for retrofitters.
- Specs: 5V handwheel with a 25’ cord. Repairable in-house.
- Fagor 100P Portable Handwheel (SKU: 8i003006)
- Compatibility: Direct 5V replacement for our CNCPD version.
- Constraint: Only available with a round connector, requiring an internal cable to be made by the retrofitter. 10’ cord.
Specialized & Legacy Replacements
Sometimes the hardware configuration of your controller dictates your choice.
- HBA-119904 Remote (SKU: 13200016): A 24V unit used when the machine uses all of the controller’s available axes. It runs completely off of I/O, not off of the controller’s normal feedback loop.
- Used Euchner Units (HBE-072502 / HBE-074614): We stock used 23-pin male connector pendants pulled from Motionmaster machines. These are excellent legacy replacements for 5V/24V convertible needs.
Tech Tip: The “Handwheel” itself is technically a Hand Pulse Generator (HPG). It’s the internal component responsible for the actual pulse counting as you click through increments.
Need help determining if your retrofit requires a 5V or 24V handwheel? Contact us today to discuss your specific controller pins and axis requirements.